Daihen OTC Welbee WB-M350, Owner'S Manual

Page: 71 / 144

6-9
Chapter 6 W
elding Condition
P
REPARING
W
ELDING
C
ONDITIONS
W
ELDING
C
ONDITION
C
HAPTER
6
6.4 Preparing Welding Conditions
This section explains the setting process of basic welding conditions.
Check welding material suitable for the welding condition
( 10.3
-
Materials for Setting Welding Conditions)
↓
Setting wire material, shield gas, and TRAVEL SPEED ( 6.6.1
-
Welding mode setting)
↓
Setting wire diameter
( 6.6.1
-
Welding mode setting)
↓
Setting crater treatment
( 6.6.3
-
Crater setting
-
)
↓
Setting pre-flow (Setting gas discharge time)
( 6.6.2
-
Setting welding parameter)
↓
Setting initial condition (Setting welding current/voltage)
( 6.6.2
-
Setting welding parameter)
↓
Setting welding condition (Setting welding current/voltage)
( 6.6.2
-
Setting welding parameter)
↓
Setting crater condition (Setting welding current/voltage)
( 6.6.2
-
Setting welding parameter, 6.6.3
-
Crater setting)
↓
Setting post-flow (Setting gas discharge time)
( 6.6.2
-
Setting welding parameter)
↓
Registering the welding conditions set above as necessary
( 6.5
-
Memory Function of Welding Conditions)