Daihen OTC ARXIS pulse P403L, Owner'S Manual

Page: 37 / 188

C
ONNECTING THE
W
ELDING
P
OWER
S
OURCE
C
ONNECTION
C
HAPTER
4
35
Chapter 4 Connection
4.2.2 Connection of wire feeder
This chapter explains the connecting procedure of the wire feeder. Refer also to the instruction manual of wire feeder.
T I P S
•
When using the voltage detection cable, the wiring for the wire feeder or welding power source needs
to be changed. (
4.6
-
Wiring of Voltage Detection Cable at Base Metal Side)
1.
Remove the cap of the socket of wire feeder and insert the control cable to the socket for the wire feeder.
●
Fit the concave part of the connector and convex part of the socket for secure connection and tighten the knurled
screws in the clockwise direction.
2.
Connect the control cable for touch panel to the socket for touch panel control.
Connection for wire feeder is complete. Procedure is followed by "4.2.3
-
Connection of welding torch".
Ground a base metal if
required by local law.
⁐᥋㟁※ ⁐᥋㟁※
㸦⫼㠃㸧 㸦⫼㠃㸧
Control cable for
wire feeder
Control cable for
touch panel
Socket for touch panel control
Socket for
wire feeder control
Welding
power source
Connector
Connector
Base metal