INSTALLATION
NOTE:
·
Basically the assembling procedure is reverse to the disassembling procedure. Therefore, some il-
lustrations are not mentioned in this assembling procedure. Refer to the illustrations in the disassem-
bling procedure in cases where any difficulty is encountered.
1. Sticking of roof silencer pad
(1) Clean the roof silencer attaching surface of the roof panel.
(2) Apply adhesive agent to the roof silencer.
CAUTION:
·
Ensure that the adhesive agent be applied to at least 90% of the roof silencer. Failure to observe this
caution may lead to producing echo or resonance noise from the roof panel.
(3) Stick the roof silencer pad to the roof panel.
2. Install the roof headlining with the attaching retainer.
CAUTION:
·
Never reuse the damaged retainer.
·
Be very careful not to bend the roof headlining during the installation.
·
Be very careful not to smear the roof headlining during the installation.
·
Make sure that each connector is located at the lamp attaching section.
3. Install the removable roof assembly. (Refer to the removable roof section.)
4. Installation of inner rear-view mirror and visor assembly
(1) Connect the connector of the roof wire to the inner rear-view mirror.
(2) Install the inner rear-view mirror with the two attaching screws.
(3) Install the room lamp cover.
(4) Install the visor holder with the attaching screw.
(5) Install the visor assembly with the two attaching screws.
(6) Connect the visor assembly to the visor holder.
5. Install the assist grip assembly with the attaching screws.
6. Place the front floor carpet in position and install the clip.
7. Install the rear floor front carpet and rear floor rear mat in position.
8. Install the child restraint anchorage. (Only for vehicles with the Australian specifications)
Tightening Torque:
15.4 - 28.6 N·m (1.57 - 2.91 kgf-m)
9. Installation of roof side inner garnish
(1) Ensure that the door trim retainers are properly installed on the back side of the roof side inner gar-
nish.
(2) Install the roof side inner garnish by engaging the retainer with the body shell. To engage the retain-
er with the body shell, lightly tap the retainer attached position of the roof side inner garnish surface
horizontally by hand.
CAUTION:
·
Be sure to tap the back side of the retainer attaching position horizontally by hand. Failure to observe
this caution may damage the retainer or other related parts.
10. Installation of deck side trim
(1) Connect the luggage room lamp connectors to luggage room lamp. (Refer to BE section of the in-
(2) Install the deck side trim.
(3) Push back the central part of the retainer one click from the position where the central part is flush
with the outer part.
(4) Install the retainer and lock the retainer by pushing the central part of the retainer until its upper sur-
face becomes flush with the outer part of the retainer.
(5) Install the rear seat outer belt assembly.
(Refer to the seat belt section for the installation procedure.)
BO–68
