POWER STEERING FLUID HOSE
Inspect the power steering fluid hose for aging, deformation,
cracks, scratches, cut, twist and swelling.
If any problem is found, replace the fluid hose with a new one.
(Refer to the SR section.)
CAUTION:
·
Never reuse the removed hose bands.
MA–42
WHEEL ALIGNMENT
TOE-IN CHECK
1. Ensure that the tires have been inflated with the specified
pressure.
(Refer to the Owner’s manual.)
2. Place the vehicle on a flat floor and place the steering
wheel to a straight ahead direction.
3. Attach a toe-in gauge to the rear side at the center point of
each front tire at a height of tire center and put a mark on
each tire.
4. Move the vehicle forward in a straight ahead direction
gradually until the marks put on the tires come to the front
side.
5. Attach the toe-in gauge to the front side, at the center
point of each front tire. Determine the difference in the
mark-to-mark distance between the first measurement and
the second measurement. This difference constitutes the
toe-in.
6. Ensure that the measured difference is within the specified
value.
Specified Value: 0
±
1.5 mm
If the measured difference(toe-in) fails to meet with the
specification, adjust the toe-in to the specified value.
(Refer to the FS section.)
A
A
B
Front
JMA00121-00101
JMA00122-00102
JMA00123-00103
