Dahua HDBW2831R-ZAS, Operation Manual

Page: 133 / 256

Operation Manual
120
Table 4-42 Description of adding IP/MAC parameters
Parameter Description
Rule Type
Select IP address, IP segment, MAC address or all IP addresses.
●
IP address: Select IP version and enter the IP address of the host to
be added.
●
IP segment: Select IP version and enter the start address and end
address of the segment to be added.
●
MAC address: Enter MAC address of the host to be added.
●
All IP addresses: Set all IP addresses in allowlist or restricted list.
Device All Ports Set access ports. You can select all ports or the ports in defined areas.
●
Device all ports: Set all IP port in allowlist or Blocklist. When
selecting BlocklList in Mode , and All IP Address in Rule Type , you
cannot select the Device All Ports checkbox.
●
Device start server port and Device end server port: Set Device start
server port and device end server port, and the range is 1–65535.
Device Start Server
Port
Device End Server
Port
Step 4 Click OK , and the Firewall interface is displayed.
Step 5 Click Save .
4.8.5 Peripheral
4.8.5.1 Serial Port Settings
Set the serial port of the external device.
Step 1
Select Setting > System > Peripheral > Serial Port Setting .
Figure 4-121 Serial port settings
Step 2 Configure serial port settings parameters.