Dahua HDBW2831R-ZAS, Operation Manual

Page: 103 / 256

Operation Manual
90
4.6.11 QoS
You can solve problems such as network delay and congestion with this function. It helps to assure
bandwidth, reduce transmission delay, packet loss rate, and delay jitter to improve experience.
0–63 means 64 degrees of priority; 0 for the lowest and 63 the highest.
Step 1
Select Setting > Network > QoS .
Figure 4-84 QoS
Step 2 Configure QoS parameters.
Table 4-30 Description of QoS parameters
Parameter Description
Realtime Monitor
Configure the priority of the data packets that used for network
surveillance. 0 for the lowest and 63 the highest.
Command
Configure the priority of the data packets that used for configure or
checking.
Step 3 Click Save .
4.6.12 5G
5G configuration includes dialing configuration and mobile configuration. Install SIM card
(Subscriber Identification Module) to the camera, and connect it to 5G network through dialing
configuration and mobile configuration.
●
Dialing configuration: Connect the camera to 5G network in a specific period.
●
Mobile configuration: Configure the mobile phone to receive the linkage message. When an
alarm is triggered, the system sends an alarm message to the receiver, and then the receiver can
active the camera and connect it to 5G network through message or call.
4.6.12.1 Dialing Setting
Configure the camera to connect it to 5G network.
Step 1
Select Setting > Network > 5G > Dialing Setting .
Step 2 Select the Enable checkbox, and configure the parameters.