Dahua HCVR8204A-S3, User Manual, Page: 245 / 446

235
Figure 4-214
Step 2 Click Add button.
Enter config interface. See Figure 4-215.
Step 3 Check the box to enable POS function and set parameters.

Name: Input POS name.
Note
◇
The POS device name shall be unique.
◇
POS device name max supports 63-digit.

Connection type: This is for net mode only. Click Setup button, you can set source IP
(POS IP address), port is the POS port. Destination IP is the DVR default Ethernet
card IP, port is the POS port (read-only). See Figure 4-216.

Network time out: If there is a network problem, DVR can wait for the specified time
you set here to send out the POS information. Once the network time is out, DVR
only send out current valid POS information when then network resumes normal.

Time display: It is to set the POS information displayed time on the video. If you set 5
seconds, then the POS information appears after 5 seconds display.

Channel Set: Click it to go to Figure 4-217. Select a channel you want to overlay POS
information and then click Save button