Dahua F4X5, Operation Manual

Page: 50 / 98

Dahua Network Speed Dome Web3.0 Operation Manual
46
Figure 4-28
Please refer to the following sheet for detailed information.
Parameter Function
SNMP Version

Check SNMP v1, device only process v1 info.

Check SNMP v2, device only process v2 info.

Check SNMP v3, can set username, password and
encryption method. Server calibrate corresponding
username, password and encryption method too access
device and v1/v2 are unavailable.
SNMP port The listening port of the proxy program of the device. It is a
UDP port not a TCP port. The value ranges from 1 to 65535.
The default value is 161
Community It is a string, as command between management and proxy, ,
defining a proxy, and a manager’s authentication.
Read community
Read-only access to all SNMP targets, default is public.
Note: Only number, letter, _, and
– supported.
Write community
Read/write access to all SNMP targets, default is private.
Note: Only number, letter, _, and
– supported.
Trap address
The destination address of the Trap information from the
proxy program of the device.
Trap
SNMP trap is a proxy message sent to admin as important
event notice or status change.
Trap Address
Address where to send Trap message.
Trap Port
Port which send Trap message, default is 162, range
1~65535.
Check SNMP v3 version and SNMP port, read community, write community, Trap address, Trap port
are same with SNMP v1 and SNMP v2 versions. Only when SNMP version is SNMP v3, user need to
configure parameter in chart. See Figure 4-29.