Dahua ESS2016X, User Manual

Page: 21 / 116

ESS Series
User’s Manual
12
3 Main control module It is about all kinds of ports and indictor light
introduction. Please refer to the following sheet.
4 Battery&fan box It is to install the battery and the case ventilation.
You can refer to the following sheet for detailed information of main control module.
Port/Indicator
Light Function
LAN1
～
LAN4
1000Mbps data Ethernet port. It is to transmit data.
10G_1, 10G_2
10000Mbps data Ethernet port. It is to transmit data. (Optional)
WEB port Ethernet Management port. Login Web via this port.
USB port USB port
PORT1/PORT2 Connect to the IN port of the disk array enclosure.
CONSOLE COM port. It is to debug the device and view the login command interface.
RUN The light is flashing after system booted up and begins running.
M/S Main control indictor light.

The light is on if it is the main controller.

The light is off if it is the slave controller.
ERR System error indictor light.

The error light is on when system is abnormal.

The error light is off when system is running properly.
CACHE
It is reserved for future use.
RST Press it for 5 seconds to restore default setup (network setup, user password,
time sync, email alarm and etc.).
1.9 ESS5048S/ ESS5048S-R
1.9.1 Front Panel
The front panel is shown as below. See Figure 1-17.
The HDD slot number ranges from left to right, from top to the bottom.