31
Right click mouse to go back to the previous interface.
4.4
PTZ
Note:
All the operations here are based on PELCOD protocol. For other protocols, there might be a
little difference.
Cable Connection
Please follow the procedures below to go on cable connection
Connect the dome RS485 port to ATM DVR 485 port.
Connect dome video output cable to ATM DVR video input port.
Connect power adapter to the dome.
PTZ Setup
Note:
The camera video should be in the current screen. Before setup, please check the following
connections are right:
PTZ and decoder connection is right. Decoder address setup is right.
Decoder A (B) line connects with ATM DVR A (B) line.
Boot up the ATM DVR, input user name and password.
In the main menu, click setting, and then click Pan/Tilt Control button. The interface is shown as in
Figure 4-15 or Figure 4-16. Here you can set the following items:
Channel: Select the current camera channel.
PTZ type: There are two options: local/remote.
Protocol: Select corresponding PTZ protocol(such as PELCOD)
Address: Default address is 1.
Baud rate: Select corresponding baud rate. Default value is 9600.
Data bit: Select corresponding data bits. Default value is 8.
Stop bit: Select corresponding stop bits. Default value is 1.
Parity: There are three options: odd/even/none. Default setup is none.
Summary of Contents for DVR0X04AH-VD-E
