Figure 3-4 Adjust the horizontal poles
Step 4
Use the 4 mm Allen wrench to tighten all the screws.
3.3.2 Installing Wall Mount Bracket
The wall mount bracket comes with 2 horizontal poles and 12 expansion screws (ST6.3).
Procedure
Step 1
Confirm and mark the installation position on the wall through tape measure or laser
level.
Step 2
Drill holes on the marked positions with diameter of 10 mm and depth of 75 mm.
Step 3
Use expansion screws to install the horizontal poles on the wall. Make them level and
justified.
Strictly confirm to the dimensions below.
Quick Start Guide
13
