Dahua DHI-ISC-EAA8000-P, User Manual

Page: 12 / 27

User’s Manual
7
3.3.2 Description of Primary Antenna TX Board Ports and Manual
Configuration of Hardware
TX board ports
Table 3-3 Description of TX board ports and manual configuration of hardware
Port Function Settings
CH1/CH2/CH3
By default,
CH1 is for connecting RX board
of primary antenna;
CH2 and CH3 is for connecting
replica antenna as needed.
Use 9 Pin cable to connect, remember that
cold plug, electrical hot plug will cause
damage to the TX board.
Power Port 1 Power input port.
Use the 5 Pin power cord to connect,
remember that cold plug, electrical hot
plug will cause damage to TX board.
USB Port
1 USB port for software
configuration.
Use the dedicated blue configuration line
to connect.
CCTV Port 1 Port per antenna. Optional, not required.
J201/J301/J401
Corresponding to the channel
signals of CH1, CH2, and CH3,
which is for strengthening the
function of noise reduction.
It is recommended to be used under the
guidance of technicians.
RESET
1 Physical button for system
reset.
When the fault indicator is red, you can
reset the system by the following steps.
1. Take out a spare jumper and install it
on J108-3&4.
2. Press the reset button once and wait
for 10 seconds.
3. Remove the jumper cap.
4. Press the RESET button again.
5.
After the system resets successfully,
there will be an alarm sound.