10
Mark the holes on the installation surface (mm[inch])
Figure 4-8
Drill holes. See the table below for hole diameters and depth, and expansion bolt diameters.
Step 4
Table 4-3
Expansion bolt specification
Item
Dimension
Expansion bolt
M12 × 120
Hole depth
95 mm
Hole diameter
16 mm
Use compressed air to remove the dust in the holes. Repeat this step no less than three
Step 5
times.
Hammer the expansion bolts into the bottom of the hole.
Step 6
Use a wrench to tighten the nuts, and then hammer the expansion bolts again.
Step 7
4.3.2
Adjusting Turnstile Position
Use the key to open the top panel.
Step 1
