Dahua DHI-ARC3008C, User Manual

Page: 58 / 137

User’s Manual
47
◇
FORCED ARM : Select YES or NO .
If YES is selected, the key zone will be armed even though there are open zones. If NO is
selected, the arming will take place only if all the area zones are ready for arming.
◇
Link: Set link output associated with the input.
●
SPECIAL
If the SPECIAL option is selected, two submenus are proposed.
◇
RESTART : This option turns off and immediately re-arms the controller. This function can be
useful to perform PATROL ROUND to disarm one or more areas getting automatic re-arm
after the programmed exit time area.
◇
TIMER OFF : This option is not subject to TRIGGER , DELAY OR FORCED and works only in the
table step from
N.C.
to
N.O.
status. When opened, it locks arming operations subject to a
TMER which are programmed for the AREAS to which it is associated. In practice, it functions
as a key to lock/unlock
ON/OFF TIMERS
active on the
AREAS
.
7.8 In and Zones
You can set maximum eight IN AND ZONES couples. For each IN AND ZONES , you can combine two
zones and establish the alarm linkage between them.
Step 1
After entering the installer menu, press and to scroll up and down until you reach
the IN AND ZONES menu.
Figure 7-7 In and zones
Step 2 Press to enter the programming mode.
Step 3 Press and to select the IN AND ZONE that you want to configure, and then press
.
By pressing + 2, you can enter the
EDITING
mode for changing the description of
IN
AND ZONE .
Step 4 Configure the parameters.
Press
and to alter the options. Press to confirm the setting and move to the
next submenu.
Table 7-4 IN AND ZONE programming settings
Submenu Setting
STATUS
●
ACTIVE : This IN AND ZONE is enabled.
●
ISOLATE : This IN AND ZONE is programed but not used.
●
OFF
: This
IN AND ZONE
is disabled.