User’s Manual
167
Parameter
Description
Log
Select the checkbox to enable the Device to record a local alarm log.
Alarm Tone
Select to enable audio broadcast/alarm tone in response to a HDD alarm
event.
Click
Apply
to complete the settings.
5.10.5.2
Configuring Network Event Settings
Select
Main Menu > ALARM > Exception > Network
.
Network
Configure the settings for the Network event.
Table 5-34
Network event settings
Parameter
Description
Event Type
In the
Event Type
list, select
Offlice
,
IP Conflict
, or
MAC Conflict
as the event
type.
Enable
Enable or disable the Network event detection function.
Alarm-out Port
Click
Setting
to configure the parameters.
General Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
External Alarm: Enable alarm activation through the connected alarm
box.
Wireless Siren: Enable alarm activation through devices connected by
USB gateway or camera gateway.
Post-Alarm
Set a length of time for the Device to delay turning off alarm after the external
alarm is cancelled. The value ranges from 10 seconds to 300 seconds, and the
default value is 10 seconds.
Summary of Contents for DH-XVR54 L-I2 Series
