8
There are two dial switch buttons on the PTZ. You can use them to set speed dome address,
baud rate and HD/SD video format respectively. It is 1 when you set the button as ON. 1 is the
lowest bit for address setup dial, 8 is the highest bit; 1 is the lowest bit for the baud rate and
HD/SD video format setup dial, 4 is the highest bit.
Please note the intelligent speed dome self-adapt PELCO-D. PELCO-P and industrial
standard protocol, the control protocol doesn
’t have to be set via dial.
2.5.2 Baud Rate and Parity Setup
Figure 2-11
For the dial switch button from 1 to 4, 1 and 2 bit is used to set baud rate, 3 and 4 bit is used to
set HD/SD video format. Please refer to the following figure for detailed information.
Please refer to the baud rate sheet for detailed information.
1
2
Baud Rate
OFF
OFF
9600bps
ON
OFF
4800bps
OFF
ON
2400bps
ON
ON
1200bps
Please refer to the HD/SD video format setup sheet for detailed information.
3
4
HD/SD video format
OFF
OFF
HD
ON
OFF
SD
OFF
ON
Self-adapt
ON
ON
HD
2.5.3 Speed Dome Address Setup
The address interface is shown as in Figure 2-5.
Figure 2-12
The encode mode adopts binary system. 1 to 8 is valid bit. The highest address bit is 255. You
can refer to the following sheet for more information.
Address
1
2
3
4
5
6
7
8
1
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
1
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
2
OFF
ON
OFF
OFF
OFF
OFF
OFF
OFF
