switch(config)# interface G1
switch(config-G1)# storm-control multicast pps 1000
6.7.3
storm-control unicast pps
Command Description
storm-control unicast pps vlaue
//This command is used to enable the unicast storm control function.
no storm-control unicast
//This command is used to disable the unicast storm control function.
Parameter
Parameter
Parameters of the command mode
value
Range:0-1000000 unit:pps,Default: 0
Default
None
Command Mode
Interface configuration mode
Example
//This command is used to limit the rate of unicast packet of Port 1 to
1000pps.
switch(config)# interface G1
switch(config-G1)# storm-control unicast pps 1000
6.8
ERPS-RING config
configuration commands include:
loop-protection
loop-protection tx-time
loop-protection transmit
Function Brief
erps-ring is similar to STP, but it lacks an IEEE standard and is a
private protocol. Loop protection is easy to configure and use. It is suitable
for a simple ring topology and common network services, and has obvious
advantages in line backup.
6.8.1
loop-protection
Command Description
loop-protection
