19
Network Type
Note
DHCP
Auto gets IP function. When you enable DHCP IP address, subnet mask
and default gateway cannot be set.
P2P Enable
No need to apply for dynamic domain, mapping port or deploying
server.
4.4.2.2
Setting IP
On the
Network Setup
screen, select
IP Setup
, and then tap
OK
.
Step 1
IP setup
Figure 4-19
Modify IP, subnet mask and gateway, and then tap
OK
.
Step 2
4.4.3
Setting Device Mode
The Device supports two Device modes, which are controller mode and card reader mode.
This device as controller
: The Device is used as a controller to control access.
This device as card reader
: The Device is used as a card reader. If you need to control door
access, it must be connected to a controller.
On the
Settings
screen, select mode setup, and then tap
OK
.
Step 1
Select the work mode, and tap
OK.
Step 2
Mode setup
Figure 4-20