4
Installing an SD Card
Disconnect power to the camera.
Remove the panel at the rear of the camera.
Gently insert the SD card into the slot until it clicks in place.
Replace the panel.
Press the Reset button for 10 seconds to reset the device.
Using the Waterproof Ethernet Connector
Attach the waterproof network connector if the camera is used outdoors.
Summary of Contents for N42BD32
Page 17: ...6 2 5 2 Mounting to a Wall Cables through Camera Base Conduit...
Page 18: ...7 2 5 3 Adjusting the Lens Angle...
Page 23: ...12...
