Dahua Technology IPC-HDW5842T-ZE, Operation Manual

Page: 149 / 473

Operation Manual
135
Figure 5-19 Alarm track
Step 2 Select the
Enable
check box to enable track linkage.
After enabling the function, manual positioning, manual tacking and auto tracking take
effect.
Step 3 Set parameters.
Table 5-3 Description of alarm track parameters
Parameter Description
Auto Track
Select On , and the speed dome automatically links to a corresponding
position and tracks an object when the intelligent rules of the
panoramic camera trigger alarms.
Track Time
Set the alarm track time.
●
Before an object disappears: The speed dome would
automatically link to a corresponding position and tracks an
object until the object moves out of the monitoring range when
the intelligent rules of the panoramic camera trigger alarms.
●
Custom: Set the auto alarm track time of the speed dome.
Idle Time It is an interval from the end of alarm track of the speed dome to the
start of idle mode.
Set
Idle Time and Idle Position . If no event needs to be tracked after
the configured idle time, the device automatically rotates to the set
idle position. For example, the
Idle Time is set to be five seconds and
the Idle Position is set to be preset point 1. When the speed dome
does not start tracking after five seconds, it automatically rotates to
preset 1.
To set
Idle Position , first set a preset point. For preset point, see
"4.3.2.1 Preset".
Idle Position
Step 4 Click Save .
5.3 Setting Panoramic Calibration
The device has calibration parameters by default, and you can modify the parameters manually