Dahua Technology DHI-LM55-F400, User Manual

Page: 10 / 41

User’s Manual
2
Notes:

For all other regions, the power cords shall be matched with the AC voltage of the power socket, conform
to the regulations of the relevant laws of the countries/territories, and pass certification. (Types H03VVH2-
F 0.75 mm2 shall be used.)

You can keep the packing case and packaging materials for later transport of the monitor.
1.3. Installation precautions

This product belongs to high-power-consumption products. Please always use the plug specially
designed for this product. If you need to extend the wire, please consult your service provider.

This product should be installed on a plane to avoid overturn. The rear part of this product should be kept
away from the wall at a certain distance so as to maintain proper ventilation. This product shall not be
installed in the kitchen, bathroom or any other locations with high humidity, to avoid shortening the
service life of the electronic components.

This product works only at an altitude below 3000m. If the installation site is higher than 3000m, some
abnormalities may occur.
1.4. Installation for the base of the mounting desk
Install the base:
1. Spread the protective film (wrapped on the monitored during packing) on the desk, and place the
monitor with its front face down on the protective film (keep the trademark off the desk) to avoid
scratching the screen.
2. Align the base according to the figure (distinguish the left and right supports). There are R and L marks on
the base. Lock screws.
3. Lift the monitor and place it.