Dafra RRT5212 Operating Instructions Download Page 1

Page: 1 / 2

160mm

210mm

Pull mandrel to remove

from tool body.

Unscrew anvil and

locknut

CAPACITY
R

ivnuts: M5 - M6 - M8 - M10 - M12

- Standard

Rivstuds: M5 - M6 - M8 - Optional

Rivnuts: UNC - 10.24, 1/4

20, 5/16

18, 3/8

.16 , 1/2.13 - Optional

IMPORTANT

- WHEN USING M5 AND M6 RIVNUTS,

ALWAYS TEST SET RIVNUTS INTO SCRAP MATERIAL.

ONLY A SMALL AMOUNT OF FORCE IS REQUIRED TO

SET THESE RIVNUTS.

UNNECESSARY OVER TIGHTENING MAY RESULT IN

DAMAGE TO THE TOOL MANDREL OR RIVNUT THREADS.

IMPORTANT - MAINTENANCE TIP

APPLY GREASE TO THE LOAD TRANSFER THREAD.

THIS IS DONE BY WINDING THE TOOL APART, CLEANING AND

GREASING THE THREAD.

MAINTENANCE TIME APPROX 5 MINUTES.

Model:

RT5

operating

instructions

Dafra Products - 1/7 Jarrah Drive Braeside, VIC, 3195 I dafra.com.au I 03 9555 6872

Summary of Contents for RRT5212

Page 1: ...TS INTO SCRAP MATERIAL ONLY A SMALL AMOUNT OF FORCE IS REQUIRED TO SET THESE RIVNUTS UNNECESSARY OVER TIGHTENING MAY RESULT IN DAMAGE TO THE TOOL MANDREL OR RIVNUT THREADS IMPORTANT MAINTENANCE TIP AP...

Page 2: ...piece Note gap increases as rivnut is set Use stoke guage for consistant setting switch down Hold forward handle still Rotate rear handle clockwise one turn Anvil will release rivnut Rotate splined k...