5.1.3. Refilling with oil
Refill with fresh engine oil at the oil filler neck.
After refilling with oil, rotate the engine with the starter and move the shut-down lever to “stop”
at the same time until the oil pressure warning light goes out and the oil pressure gauge shows
a pressure.
Then start the engine and allow it to run at medium speed for a few minutes. Check oil pressure
and tightness of system.
Then shut down the engine. After about 5 minutes, check the oil level. The oil level should now
be at the upper notch of the dipstick, but not higher.
Add any necessary oil to the upper dipstick mark.
5.1.4. Lubricating oil filter
Cleaning of the lubricating oil is effected in
a full-flow oil filter with paper cartridges. A
bypass valve ensures continuity of oil
supply if the filter elements should be
clogged.
After draining off the oil release tie screw.
Remove filter bowl. Renew filter cartridge.
Thoroughly clean all other parts in
cleaning fluid. Use new gaskets for re-
assembly.
During continuous operation the selector lever that both filter halves are in operation.
Observe positions of selector level.
CAUTION : Do not leave selector lever in any intermediate position because this would be
liable to interfere with oil supply.
- 26 -
EA6O5003
1
2
3
3
4
EA6O5004
Right-hand filter cut out
Left-hand filter cut out
Continuous operation
(both filter halves in
operation)
1. Oil filter(Change over-type)
2. Element
3. Oil drain pulg
4. Selector cock
