pipe is to be installed, and install the
oil suction pipe by tightening the
fixing bolts.
•
Assemble the pipe bracket on the
cylinder block side with bolts.
9.3.17. Oil pan
•
Clean thoroughly the gasket that is
projecting at the junction parts of
front oil seal holder and flywheel
housing of cylinder block's lower
face with a scraper. In the process of
gasket removal, be careful for the
gasket pieces not to get into the
engine inside.
•
Attach the gasket to the cylinder
block.
•
Install the oil pan and tighten the
fixing bolts. Then take care not to
squeeze out the gasket.
•
Install the guide tube and insert the oil level gauge.
9.3.18. Cylinder head
•
Blow the cylinder head bolt holes with compressed air to remove the foreign material
cleanly.
•
Wipe off cleanly the junction part of
cylinder block's head gasket.
•
After confirming whether there is
foreign material or not necessarily, if
there is, remove it.
•
Assemble the gasket fitting with the
fixing pin of the cylinder block.
•
Fit the cylinder head assembly on
the cylinder block aligning with its
dowel pin. (Take care not to damage
the head gasket.)
•
Coat the cylinder head bolts with
engine oil and tighten them to the
specified torque according to step by
step. However, prior to tightening the
bolts, with a long steel rule, the
parallel between the cylinder heads
must be adjusted.
- 102 -
EFM2075I
EFM2076I
