9.3.14. Front oil seal holder
•
After placing the oil seal in the oil
holder hole properly, press it in with a
mandrel. (Be careful for oil seal not
be damaged.)
•
Attach the gasket at oil seal holder.
•
Align the dowel pin with the oil seal
holder dowel hole and assemble
them by tapping lightly the dowel pin
part with an urethane hammer. When
in assembling, take care not to hurt
the oil seal by the crankshaft.
NOTE : Without coating the oil seal with oil or
lubricant, assemble it in the dry
state.
•
Tighten the fixing bolts in the zigzag
method.
9.3.15. Vibration damper
•
Assemble the vibration damper
tightening firstly by the crankshaft
pulley and the fixing bolts.
•
Insert the crankshaft pulley
assembly to the crankshaft and
tighten the fixing bolts in the method
of zigzag to the specified torque.
9.3.16.Oil pump
•
Put the oil pump at the place to be
installed on the cylinder block.
•
Attach the gasket at the surface of oil
pump where the pressure regulating
valve is to be installed and place the
regulating valve on the gasket.
•
Assemble the oil pump by tightening
the fixing bolts.
•
Attach the gasket at the surface of
the oil pump where the oil suction
- 101 -
EFM2073I
EFM2092I
EFM2074I
Torque
20 kg.m
