Daewoo DW-3000 Series, Training Manual

Page: 8 / 75

1-6. Gear Housing
(at 60Hz)
1-7. Spin Bellows Assembly
Brake Band Gap Control Method
The Band Brake works best when the gap between it and the Drum Coupling is about 2mm
when the Door Spin *0 is closed. The Spin Dryer stops slowly if the gap is larger in which
case the screw of the Wire Guide may be loosened and adjusted upwards. If the gap
between the two is too narrow, the Spin Dryer revolution is affected and the Wire Guide may
be adjusted downward to maintain the Brake Band gap adequately.
The initial deceleration following the activation of the Wash Motor takes place through the
Motor Pulley and the Agitator Pulley, and the secondary deceleration is done by the gears in
the Gear Housing which also increases their revolution strength. This revolution speed and
strength is delivered to the Agitator, which is then able to cause water current that is strong
yet soft so that wash loads are not damaged.
The wrinkled rubber device on the
bottom of the spindryer is called
Spin Bellows assembly. It has a
waterseal and a oilless
m
etal
inside to prevent leakage and so
that the Spin Dryer may work
smoothly.
WASH MOTOR
(MOTOR PULLEY)
about 1600 RPM
AGITATOR PULLEYS
about 271 RPM
AGITATOR
about 65 RPM
4.18:1
5.91:1 V-BELT
GEAR HOUSING
ASS'Y
5