DAELIM VJF125, Service Manual

Page: 246 / 288

17-5
BATTERY/CHARGING SYSTEM
REGULATOR/RECTIFIER
HARNESS SIDE CIRCUIT INSPECTION
Remove the seat. (
⇨
13-2 )
Remove the LH. side cover. (
⇨
13-2 )
Disconnect the regulator/rectifier coupler.
Inspect the wiring circuits at each terminal of the wire
harness side.
Inspection Items
Check that there is voltage between
battery line (+) and ground line.
Check continuity between ground and
frame.
Check that the resistance of the coil is
within the specified range. (0.1~1.5
Ω
)
Check not continuity between coil and
frame.
Check that there is battery voltage
between voltage detection line (+) and
ground wire the ignition is ON.
ITEM INSPECTION
BATTERY
WIRE(RED)
GROUND
WIRE(GREEN)
CHARGING
COIL WIRE
(YELLOW)
VOLTAGE
DETECTION
LINE (BLACK)
REGULATOR / RECTIFIER UNIT INSPECTION
If all inspections on the wire harness side are normal
and there are no loose connections at the regulator
rectifier coupler, inspect the regulator rectifier unit by
measuring the resistance between the terminals.
•
Resistance value will not be accurate if the probes
touch your fingers.
•
Use the following recommended tester.
•
Using another manufacturer’s equipment may not
allow you to obtain the specified values.
REGULATOR RECTIFIER
REGULATOR RECTIFIER REGULATOR RECTIFIER
REGULATOR RECTIFIER
REGULATOR RECTIFIER REGULATOR RECTIFIER REGULATOR RECTIFIER
REGULATOR RECTIFIER
REGULATOR RECTIFIER REGULATOR RECTIFIER REGULATOR RECTIFIER
REGULATOR RECTIFIER
REGULATOR RECTIFIER REGULATOR RECTIFIER REGULATOR RECTIFIER
REGULATOR RECTIFIER
Replace the regulator rectifier unit if the resistance
value between the terminals is abnormal.
TOOL : MULTI TESTER
28~36
28~36
‘ ’ indicate more than 1[M
Ω
]
B