DAELIM S4 four, Owner'S Manual

Page: 36 / 68

34
CHANGING ENGINE OIL
BRAKE HOSE, PIPE LEAKAGE,
DAMAGE, ASSEMBLY STATE
BRAKE PAD WEAR
Visually check for fluid leaks or damage
and, using a spanner, check joints and
clamps for clearance.
Also, check hose and pipe protective parts
to see if they contact other parts when
turning the handle bars or due to vibration
when driving.
Brake pad wear depends upon the severity
of usage, the type of riding, and road
conditions. (Generally, the pads will wear
faster on wet and dirty roads.)
Inspect the pads at each regular
maintenance interval (page 31).
[FRONT / REAR BRAKE]
●
Check the cutout in each pad.
● If either pad is worn to the cutout,
replace both pads as a set
●
See your authorized Daelim dealer for
this service.
<FRONT BRAKE> When the engine oil is contaminated, the life
of engine will be remarkably shortened.
Keep the proper oil level, kind and replacing
period.
● Place the vehicle on a flat surface, and idle
(warm up) the engine 2~3 minutes.
● Stop the engine, separate the oil level
gauge, place a vessel under the engine,
and remove the oil drain bolt to drain the
oil.
● Remove the adjusting hole cap, and clean
the oil filter screen.
● Check the condition of O-ring of oil filter
screen.
● Install the oil filter screen, spring,
adjusting hole cap.
● Install the oil drain bolt.
● Check the oil level gauge, and add the
engine oil until it reaches the specified
level (between max and min)
● Install the oil level gauge, and idle the
engine for a while.
● Wait for 20~30 seconds after stopping the
engine, check again the oil level gauge.
CUTOUTS