background image

IMPORTANT 

1.  Before beginning installation, please thoroughly read and become familiar with these instructions. 

2.  Installation and service must be completed by a qualified installer or service agency.

3.   Installer: Please leave these Installation Instructions with the owner.

4.   Owner: Please keep these instructions for local electrical inspector’s use and for future reference.

5.  Read the accompanying Use & Care Manual prior to operating this appliance.

TABLE OF CONTENTS

STEP  1  Verifying package contents 

Page  2

STEP  2  Gas supply requirements 

Page  2

STEP  3  Electrical power supply requirements 

Page  2

STEP  4  Gas and electrical rough-in locations 

Page  2

STEP  5  Cabinet and countertop preparation 

Page  2-3

STEP  6   Overall dimensions 

Page  3-4

STEP  7   Installing the anti-tip bracket 

Page  4

STEP  8   Removing the oven door 

Page  4

STEP  9  Removing the kick panel 

Page  4

STEP  11  Electrical connection 

Page  4-5

STEP   12  Gas connection 

Page  5

STEP  13  Installing the range 

Page  5

STEP  14  Installing the burner components 

Page  5

STEP  15  Re-installing the oven door 

Page  5

STEP  16  Verifying proper operation 

Page  6

Part No. 65166  Rev. J

TESTEd IN ACCORdANCE wITh ThE LATEST EdITION OF ANSI Z21.1 STANdARd FOR hOUSEhOLd GAS 

COOkING APPLIANCES.

NOTES: 

 

Contain helpful hints and tips to facilitate the installation.

CONVENTIONS USEd IN ThESE INSTRUCTIONS

wARNINGS:

 

Must be followed carefully to avoid personal injury or damage.

SAVE ANd REAd ThESE INSTRUCTIONS

Installation Instructions

Preference

®

 and Millennia

 Ranges

 

 

 

 

 

 

 

 

 

 

 

 

        For use with models: MRES30, RSD30, RSE30

Preliminary

For 

Review 

Only

Summary of Contents for Preference RSE30









Reviews: