English 69
C
ar
e and maint
enanc
e
Removing your oven’s convection filter
When the oven is cool, put your fingers
around the edges of the filter and gently
push up.
To clean the filter
Soak it in hot, soapy water. Rinse well. You may also place it in a dishwasher on
the top rack. Dry the filter before re-installing it.
Installing your oven’s convection filter
Clips
Carefully hook the metal clips on the back
of the filter over the metal bar across the
fan hole. Make sure it is centered over the
hole. Be careful not to scratch the porcelain
surfaces with the back of the filter
Care and maintenance
Care and cleaning of the oven
Cleaning painted parts and decorative trim
•
For general cleaning, use a cloth with hot, soapy water.
•
For more difficult residue and built-up grease, apply a liquid detergent directly
onto the area and leave for 30 to 60 minutes. Wipe with a damp cloth and dry.
Do not use abrasive cleaners on any oven surface. They can be scratched.
•
Clean soil from the porcelain surfaces of the door outside of the door gasket.
Rinse surfaces well with a solution of vinegar and water, then wipe dry.
Heavily soiled areas may be cleaned with a non-scratching scouring pad.
Cleaning stainless-steel surfaces
1.
Shake a bottle of stainless-steel Appliance Cleaner or Polish well.
2.
Place a small amount of stainless-steel appliance cleaner or polish on a damp
cloth or damp paper towel.
3.
Clean a small area, rubbing with the grain of the stainless steel if applicable.
4.
Dry and buff with a clean, dry paper towel or soft cloth.
5.
Repeat as necessary.
NOTE
•
Do not use a steel-wool pad. It will scratch the surface.
•
If a mineral oil-based stainless-steel appliance cleaner has been used before to
clean the appliance, wash the surface with dishwashing liquid and water prior
to using the stainless-steel appliance cleaner or polish.
Convection filter
The convection filter is located in the back of each oven chamber.
Clean the filter regularly. If you allow it to become clogged, the oven’s convection
cooking modes will not work properly.
You also need to remove the filter during the self-clean cycle.
NOTE
For your safety and proper oven performance, re-install the filter before using the
oven to cook. If you don’t, the spinning fan blades at the back of the oven will be
exposed.
