All specifications subject to change without notice.
Phone: (800) 793-0093
www.dacor.com
PLANNING
GUIDE
DR30ES, DR30EFS, DR30EIS, DR30EIFS
Distinctive
™
30” Wide
Electric Ranges
Document # PG05-008
Revised 10/30/12 Page 1/4
warning
•
Observe all governing codes and ordinances during planning
and installation. Contact your local building department for
further information.
•
This appliance must be installed in accordance with the
accompanying installation instructions.
All tolerances ±1/16” (±1.6 mm) unless otherwise noted.
OvERALL DEPth DImENSIONS - SIDE vIEW
Product Dimensions
AvAILAbLE bAckGUARDS
Part number
Description
Compatibility
ADRB30E03
3 Inch
Optional on all models
ADRB30E06
6 Inch
Standard on models DR30ES, DR30EFS
Optional on models DR30EIS, DR30EIFS
ADRB30E09
9 Inch
Optional on all models
Models DR30EIS and DR30EIFS come equipped from the factory with flat stainless trim piece in place
of a backguard. A backguard may be purchased as an optional accessory.
The trim on models DR30ES and DR30EFS are not compatible with a raised vent.
Models DR30EIS and DR30EIFS are compatible with Dacor raised vent models ERV3015. Use only
theses specified raised vent models.
Dimension
Dr30ES
Dr30EiS
Dr30EFS
Dr30EiFS
A
46 1/8” (117.2 cm)
46” (116.8 cm)
B
27 3/4” (70.5 cm)
27 5/8” (70.2 cm)
C
25 3/8” (64.5 cm)
25 1/4” (64.1 cm)
D
23 1/4” (64.1 cm)
23 1/8” (58.7 cm)
1” (2.5 cm)
Front of open door
Front of handle/knobs
Front panel
Rear of front panel
Backguard thickness
3” (7.6 cm)
backguard*
External handle
shown, some models
have integral handle
(see inside cover)
6” (15.2 cm)
backguard*
*
See table for compatibility
Product width:
29 15/16” (76.0 cm)
35”
(88.9 cm)
to
37”
(94.0 cm)
9” (22.9 cm)
Backguard*
A
B
C
D
DR30EI[F]S:
3/8” (9.5 mm)
DR30E[F]S:
Full stainless
steel side panels
DR30EI[F]S:
3” (7.6 cm)
partial stainless
steel side panels
(removable)
