Dacor DHD U990W/DA Series, Installation Instructions Manual

Page: 14 / 60

ENGLISH 14
Vent cover bracket installation
1. Assemble the 3 pieces of the vent cover bracket with
4 - 4.2 x 8 mm screws provided using the Torx 20
adapter. The assembled bracket should be sized to fit
inside the upper vent cover.
D
A
C
B
A. Vent cover bracket assembly
B. Upper vent cover
C. 4 - 4.2 x 8 mm screws
D. Centerline
2. Position vent cover bracket on wall about ¹⁄₈” (3.0 mm)
away from the ceiling.
3. Mark the hole locations.
A. 2 - 8 x 40 drywall anchors
B. Centerline on wall
C. Vent cover support bracket
D. 2 - 5 x 45 mm screws
E. Centerline of bracket
A
B
C
E
D
4. Drill ³/₈” (9.5 mm) holes for wall anchors and insert
anchors flush with the wall.
Complete preparation
We recommend that a qualified technician install the
hood. It is the installer’s responsibility to ensure the hood
complies with the installation clearances specified for the
product.
1. Determine and make all necessary cuts in the wall
for the vent system. Install the vent system before
installing the hood. See “Venting Requirements”
section.
2. Determine the required height for the home power
supply cable and drill a 1 ¹⁄₄” (3.2 cm) hole at this
location.
3. Run the home power supply cable according to the
National Electrical Code or CSA Standards and local
codes and ordinances. There must be enough ¹⁄₂”
conduit and wires from the fused disconnect (or
circuit breaker) box to make the connection in the
hood’s electrical terminal box.
NOTE
Do not reconnect power until installation is complete.
Installing the single fan hood
1. Using 2 or more people, hang hood on 2 mounting
screws through the mounting slots on back of hood.
C
A
B
A. Mounting screws
B. Mounting slots
C. Lower mounting screws
2. Mark with a pencil the lower mounting holes
location (C).
3. Uninstall the hood assembly, and drill ³⁄₁₆” (4.8 mm)
pilot holes at marked locations.
4. Hang the hood again on 2 upper mounting screws (A).
5. Level the hood and tighten upper mounting screws
(A).
6. Install 2 - 5 x 45 mm lower mounting screws and
tighten (C).
Use the optional wall anchors if needed.
Installation