Operations
English
25
Indicators
Control Lock
indicator
Lights up if Control Lock is activated, and blinks for
several seconds if any button except for the
POWER
button is pressed.
Self Clean indicator
Lights up if Self Clean is activated, and blinks for
5 seconds every 20-22 cycles. The cycle counter
disappears when the Self Clean cycle is complete, or the
dishwasher reaches the 23
rd
cycle.
Rinse Refill
indicator
Lights up if the dishwasher runs out of rinse aid.
NOTE
All indicators light up when the dishwasher enters Standby mode or is stopped. However,
they all turn off when the dishwasher is operating.
Simple steps to start
1.
Open the door, and then load the dishwasher. Make sure dishes are empty.
2.
If applicable, put the dishes in the lower rack. If adding the Zone Booster option, put
the dishes in the left side of the lower rack.
3.
Apply detergent to the detergent dispenser. For better results, add rinse aids.
4.
Press
POWER
, and then select a cycle with necessary options (Speed Booster, Sanitize,
etc). Availability of cycles depends on the model.
5.
Press
START
, and then close the door. The dishwasher starts the cycle after draining for
a few seconds.
NOTE
• To change the cycle after it has started, press and hold
START
for 3 seconds to cancel
the cycle. Then, select a new cycle.
• The default cycle is Normal.
• To resume after you open the door to stop the dishwasher while operating, simply
close the door.
DACOR_DW9500MD_DD68-00196A-05_EN.indd 25
DACOR_DW9500MD_DD68-00196A-05_EN.indd 25
2021-06-14 오후 4:01:35
2021-06-14 오후 4:01:35
