English
27
About Oven Functions
Before sliding the range into the cabinet
Gas line
Regulator connection
1.
Turn off the gas-supply valve, and turn off power to
the range.
2.
Connect a flexible gas line to the shut-off valve
installed on the stub out. The line must be long
enough that the range can be pulled out for service
without disconnecting the line.
3.
Slide the gas line up through the chassis' access holes
to the regulator. (Move the wires inside the access
holes to keep them from catching on the gas line.)
4.
Connect the gas line to the regulator.
5.
Turn off all cooktop controls, then turn on the gas
supply.
6.
With a soap-and-water solution, check all lines and
connections for leaks.
7.
Turn off the gas-supply valve.
Final Installation
1 1/4" *
* Distance to floor.
4 1/16" to 5 5/16"
Back of range
Anti - Tip Foot
(location varies)
Rear leg
up
1 1/4" *
down
1.
Peel the protective sheeting from the range.
2.
Measure from floor to countertop. Adjust the leveling
legs as needed to position the trim around the
cooktop even with or above the countertop.
3.
Turn to lower the anti-tip foot at the back of the
range until it is 1/16” (2 mm) off the floor.
4.
Slide the range into the cutout so the anti-tip foot
engages the anti-tip bracket. (Use a flashlight to
verify.)
5.
With a level, check that the range does not tilt in
any direction. (Adjust the legs to level the range as
needed.)
Anti-tip
bracket
Anti-tip foot
INSTALL_DOP48M86D_DG68-01454A-00_EN+MES+CFR.indb 27
INSTALL_DOP48M86D_DG68-01454A-00_EN+MES+CFR.indb 27
2022-08-05 오후 5:00:25
2022-08-05 오후 5:00:25