25
Work positions
The Equipo’s panel has programmable working positions. To setup, only set the chair’s position and
the desired reflector’s intensity and keep the work position key pressed for 3 seconds, the chair will
beep for a while informing that the position has been already programmed.
Programming water in cup holder / bowl
**
To set the time of water flux in the cup holder (10) / bowl (09), hold down the corresponding key,
3 short beeps will be displayed indicating the programming mode.
Release the key after the desired time interval. The flow time is recorded.
The maximum time for programming is 60 seconds, exceeding this limit will beep an error indicating
that the time has not been programmed.
Retractable arm drive
**
To release the arm fall, press the key (11).
How to provision the reservoirs (Water - Syringe / Handpieces)
Remove the reservoir uncoiling it on clockwise and make the replacement of water.
After the replacement put it back coiling on anticlockwise. Always use filtered water or aseptic
products.
Automatic movement to the back to zero position - V0
Press the key (07) so that the seat and backrest simultaneously return to the zero position. This is
the most comfortable position for the patient to enter / exit the Dental Chair.
To stop the movement, actuate the pedal in any direction or quickly press the key (07). The reflector
will automatically turn off after pressing the button (07).
Activation of the dental light
Press and release the key (01) to turn the Dental Light on or off.
To change the luminous intensity of the Dental Light, hold down the key until the Dental Light
reaches the desired intensity.
Emergency stop
**
When the “Emergency stop” (17) key is pressed, the LED will be on and all chair movements are
interrupted until pressed again (17). This operation does not cancel the positions and settings
already recorded. We recommend using it during long surgical procedures, as the chair will be
blocked, preventing unexpected movements.
Returns to the last position "Spit Position
**
"
Pressing the button "Return to the last position" Spit Position "(08), the reflector will turn off (if it is
on), it will start the water flow in the tank (until the programmed time or if you have not programmed,
for 30 seconds) and the backrest will fully go up to the Spit Position, when triggered again, the
backrest will return to the previous position and the reflector will turn on.
OPERATION OF EQUIPMENT
**
Functions available for
PAD control panel 17 keys.
