Reset procedure:
With the power off, press and hold the “TUNER
PRESET CH +” button, the “TUNER PRESET CH -”
button, and the “POWER” button simultaneously
on the AVR for a few seconds until the display
starts flashing at intervals of about 1 second.
Resetting the micro is a procedure used to "reboot" the microprocessor to restore its normal operation when it temporarily freezes, locks
up, or behaves erratically. Resetting the microprocessor, erases any saved settings you may have previously programmed into the unit
Issues that can affect the performance of the microprocessor:
•
A jolt of static electricity
•
Current surge through an input
Before resetting the microprocessor;
•
Check all connections carefully
•
Check for setup errors
•
Back up your settings. You may also want to write down your preferred settings for easier task of setting up the AVR after reset.
Note: The Web (Browser) Control feature can be used to back up your settings by saving a configuration file on your hard drive. For this
feature, we recommend using one of the following web browsers: Internet Explorer 10 and above, Mozilla Firefox 24 and above, Google
Chrome 29 and above, and Safari 5.x and above.
Note: If you had an installer setup your system, please first contact your installer to see if they can reset and then setup your system again
as there may be specific EQ calibrations (Audyssey) that the installer will need to perform.
Important:
Back up the settings before resetting the microprocessor. Most settings are reset to the factory default values after performing
this procedure. This means that all the settings data will be completely lost if it’s not previously saved.
Reset
Power/Standby
button
SOURCE SELECT
SOURCE SELECT
11
