D-Link xStack DGS-3426, User Manual

Page: 90 / 356

xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 6- 43. Static/Default Route Settings – Add window
The following fields can be set:
Parameter Description
IP Address Allows the entry of an IP address that will be a static entry into the Switch’s Routing Table.
Subnet Mask Allows the entry of a subnet mask corresponding to the IP address above.
Gateway Allows the entry of an IP address of a gateway for the IP address above.
Metric (1-65535) Allows the entry of a routing protocol metric representing the number of routers between
the Switch and the IP address above.
Backup State The user may choose between
Primary
and
Backup.
If the Primary Static/Default Route
fails, the Backup Route will support the entry. Please take note that the Primary and
Backup entries cannot have the same Gateway.
Click Apply to implement changes made.
IPv6 Static/Default Route Settings
A static entry of an IPv6 address can be entered into the Switch’s routing table for IPv6 formatted addresses. To view the
following window, click
Administration > Routing Table > IPv6 Static/Default Route Settings .
Figure 6- 44. IPv6 Static Route Settings window
This window shows the following values:
Parameter Description
IPv6 Address/PrefixLen The IPv6 address and corresponding Prefix Length of the IPv6 static route entry.
Interface The IP Interface where the static IPv6 route is created.
Next Hop Address The corresponding IPv6 address for the next hop Gateway address in IPv6 format.
Metric (1-65535) The metric of the IPv6 interface entered into the table representing the number of
routers between the Switch and the IPv6 address above. Metric values allowed are
between 1-65535.
Protocol Represents the status for the IPv6 routing table entry.
76