D-Link xStack DGS-3426, User Manual

Page: 200 / 356

xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 9- 15. Access Rule Table
Click Add Rule to open the next screen to configure the IPv6 entry for an access rule.
Figure 9- 16. Access Rule Configuration – IPv6
To set the Access Rule for the Packet Content Mask , adjust the following parameters and click Apply .
Parameter Description
Profile ID
This is the identifier number for this profile set.
Mode Select
Permit
to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select
Deny
to specify that packets that match the access profile are not forwarded by the Switch
and will be filtered.
Access ID Type in a unique identifier number for this access rule. This value can be set from 1 - 128.
Type
Selected profile based on Ethernet (MAC Address), IP address or IPv6 address
Ethernet
instructs the Switch to examine the layer 2 part of each packet header.
IP
instructs the Switch to examine the IP address in each frame's header.
IPv6
instructs the Switch to examine the IPv6 address in each frame's header.
Priority This parameter is specified to re-write the 802.1p default priority previously set in the Switch,
which is used to determine the CoS queue to which packets are forwarded to. Once this field is
186