D-Link xStack DGS-3426, User Manual

Page: 199 / 356

xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
Destination IP Destination IP Address- Enter an IP Address mask for the destination IP address.
DSCP (0-63)
This field allows the user to enter a DSCP value in the space provided, which will instruct the
Switch to examine the DiffServ Code part of each packet header and use this as the, or part of the
criterion for forwarding. The user may choose a value between 0 and 63.
Protocol
Specifies that the Switch will examine the Protocol field in each packet and if this field contains the
value entered here, apply the appropriate rules.
•
user define
−
Enter a hexadecimal value in the form
0x0-0xfffffff
that will identify the
protocol to be discovered in the packet header.
Port The Access Rule may be configured on a per-port basis by entering the port number of the switch
in the switch stack into this field. When a range of ports is to be configured, the
Auto Assign check
box MUST be clicked in the Access ID field of this window. If not, the user will be presented with
an error message and the access rule will not be configured. The port list is specified by listing the
lowest switch number and the beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the range (also separated by a colon)
are specified. The beginning and end of the port list range are separated by a dash. For example,
1:3 specifies switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3 - 2:4 specifies all of
the ports between switch 1, port 3 and switch 2, port 4
−
in numerical order. Entering
all
will denote
all ports on the Switch.
Rx Rate Use this to limit Rx bandwidth for the profile being configured. This rate is implemented using the
following equation: 1 value = 64kbit/sec. (ex. If the user selects an Rx rate of 10 then the ingress
rate is 640kbit/sec.) The user many select a value between 1- 156249 or
No Limit
. The default
setting is No Limit.
Time Range Click the check box and enter the name of the Time Range settings that has been previously
configured in the
Time Range window. This will set specific times when this access rule will be
implemented on the Switch.
To view the settings of a previously correctly configured rule, click in the Access Rule Table to view the following screen:
Figure 9- 14. Access Rule Display window (IP)
To configure the Access Rule for IPv6 , open the Access Profile Table and click Modify for an IPv6 entry. This will open the
following screen:
185