74
D-Link M30 AX3000 Dual-Band Wi-Fi 6 Router User Manual
Section 3 - Configuration
Firewall Settings - IPv4/IPv6 Rules
Name:
Enter a name for the rule.
Source IP Address
Range:
Enter the source IP address range (e.g. 1.1.1.1-1.1.1.2 for IPv4
or 2001::1-2001::2 for IPv6) that the rule will apply to, and using the
drop-down menu to specify whether it is a
WAN
or
LAN
IP address.
Both a single IP address and a range of IP addresses
can be entered.
Destination IP
Address Range:
Enter the destination IP address range (e.g. 1.1.1.1-1.1.1.2
for IPv4 or 2001::1-2001::2 for IPv6) that the rule will apply to, and
using the drop-down menu to specify whether it is a
WAN
or
LAN
IP address. Both a single IP address and a range of IP addresses can
be entered.
Protocol & Port
Range:
Select a traffic protocol to allow or deny (
Any
,
TCP
, or
UDP
) and then
enter a range of ports (e.g. 21-23) that the rule will apply to. Select
Any to allow/deny all types of traffic regardless of the port number.
Schedule:
Use the drop-down menu to select a time schedule that the rule will
be enabled on. The schedule may be set to
Always Enable
, or you
can create your own schedules in the
Schedule
section. Refer to
for more information.
Click
Apply
when you are done.
To create a new rule, click on the
Add Rule
button. Click
Save
when you are done. A maximum of 24 rules can be defined. If
you edit or create a rule, the following options will appear:
