78
D-Link DIR-1960 User Manual
Section 4 - Configuration
System Admin
This page will allow you to change the administrator (Admin) password and
enable remote management. In the Management menu on the bar on the top
of the page, click
Admin
. To load, save, reset settings, or reboot the router, click
System
and refer to
Admin Password
Password:
Enter a new password for the administrator account. You will need to
enter this password whenever you configure the router using a web
browser.
Enable Graphical
Authentication
(CAPTCHA):
Enables a challenge-response test to require users to type letters or
numbers from a distorted image displayed on the screen to prevent
online hackers and unauthorized users from gaining access to your
router’s network settings.
Advanced Settings - Administration
Enable HTTPS
Server:
Check to enable HTTPS to connect to the router securely. Instead of using
http://dlinkrouter.local./
, you must use
https://dlinkrouter.local./
in
order to connect to the router.
Enable Remote
Management:
Remote management allows the DIR-1960 to be configured from the
Internet by a web browser. A password is still required to access the web
management interface.
Remote Admin
Port:
The port number used to access the DIR-1960 is used in the URL. Example:
http://x.x.x.x:8080
where x.x.x.x is the Internet IP address of the DIR-1960
and 8080 is the port used for the web management interface.
Note:
If you enabled
Use HTTPS
and wish to access the router remotely and
securely, you must enter
https://
at the beginning of the address.
Click
Save
when you are done.
