4 Configuration
D-Link DXS-1210 Series User Manual
34
Management > D-Link Discover Protocol Settings
The D-Link Discover Protocol Settings page allows you to configure and display D-Link Discovery Protocol
(DDP).
Figure 4.56 – Management > D-Link Discover Protocol Settings
D-Link Discovery Protocol State:
Enter
the enable or disable the D-Link Discovery Protocol state.
Report Timer:
Specify the interval in seconds between two consecutive DDP report messages. Options to
choose from are
30
,
60
,
90
,
120
, and
Never
.
DDP Port Settings:
From Port / To Port:
Enter
the appropriate port range used for the configuration.
State:
Select to enable or disable the DDP port state.
Click the Apply button to save your settings.
L2 Features > FDB > Static FDB > Unicast Static FDB
The Unicast Static FDB
page allows you to view and configure the static unicast forwarding settings on the
Switch.
Figure 4.57 – L2 Features > FDB > Static FDB > Unicast Static FDB
Port / Drop:
Allows the selection of the port number on which the MAC address entered resides. This option
could also drop the MAC address from the unicast static FDB. When selecting
Port
, select the switch unit
and port number.
VID (1-4094):
Enter
the VLAN ID on which the associated unicast MAC address resides.
MAC Address:
Enter
the MAC address to which packets will be statically forwarded or dropped. This must
be a unicast MAC address.
Click the
Apply
button to save your settings or click the
Delete All
button to delete all the entries found in the
display table.
Summary of Contents for DXS-1210 Series
Page 2: ......
Page 23: ...4 Configuration D Link DXS 1210 Series User Manual 1 17 7 Figure 4 24 User Guide Micro Site ...
Page 119: ......
