D-Link Unified Access System
Software User Manual
12/10/09
Page 504
Monitoring and Managing Intrusion Detection
Document
34CSFP6XXUWS-SWUM100-D7
If you use the local database for AP Validation, you can click the
WLAN > Administration > Basic Setup > Valid AP
tab
to modify the AP configuration. If you use a RADIUS server for AP validation, you must add the MAC address of the AP to
the RADIUS server database.
Click the MAC address of the AP to view more information about the AP. If the AP is not a D-Link AP, some values are
unknown.
To view additional data (beacon information) for an AP in the authentication failure list, you can search for the MAC address
of the failed AP on the Rogue/RF Scan page. However, some APs that attempt to contact the switch on the wired network
might not be detected during the RF scan.
Figure 350: AP Authentication Failure Details
describes the fields on the detailed
Access Point Authentication Failure Status
page.
Table 326: Access Point Authentication Failure Status
Field
Description
MAC Address
The Ethernet address of the AP. If the MAC address of the AP is followed by an
asterisk (*), it was reported by a peer switch.
IP Address
The IP address of the AP.
Last Failure Type
Indicates the last type of failure that occurred, which can be one of the following:
•
Local Authentication
•
No Database Entry
•
Not Managed
•
RADIUS Authentication
•
RADIUS Challenged
•
RADIUS Unreachable
•
Invalid RADIUS Response
•
Invalid Profile ID
•
Profile Mismatch-Hardware Type
Age
Time since failure occurred.
