D-Link DWS-4000 Series, Cli Command Reference

Page: 56 / 566

D-Link Unified Switch CLI Command Reference
48
© 2009 D-Link Corporation. All Rights Reserved
no switchport protected (Global Config)
Use this command to remove a protected port group. The
groupid
parameter identifies the set of protected ports. Use the
name
keyword to remove the name from the group.
switchport protected (Interface Config)
Use this command to add an interface to a protected port group. The
<groupid>
parameter identifies the set of protected
ports to which this interface is assigned. You can only configure an interface as protected in one group.
no switchport protected (Interface Config)
Use this command to configure a port as unprotected. The
groupid
parameter identifies the set of protected ports to which
this interface is assigned.
show switchport protected
This command displays the status of all the interfaces, including protected and unprotected interfaces.
show interfaces switchport
This command displays the status of the interface (protected/unprotected) under the groupid.
Format
NO switchport protected <groupid> name
Mode Global Config
Note: Port protection occurs within a single switch. Protected port configuration does not affect traffic between
ports on two different switches. No traffic forwarding is possible between two protected ports.
Default unprotected
Format
switchport protected <groupid>
Mode Interface Config
Format
no switchport protected <groupid>
Mode Interface Config
Format
show switchport protected <groupid>
Mode • Privileged EXEC
• User EXEC
Term Definition
Group ID The number that identifies the protected port group.
Name An optional name of the protected port group. The name can be up to 32 alphanumeric characters
long, including blanks. The default is blank.
List of Physical
Ports List of ports, which are configured as protected for the group identified with <groupid>. If no port is
configured as protected for this group, this field is blank.