D-Link DWS-4000 Series, Cli Command Reference

Page: 450 / 566

D-Link Unified Switch CLI Command Reference
442
© 2009 D-Link Corporation. All Rights Reserved
DHCP S
ERVER
C
OMMANDS
This section describes the commands you to configure the DHCP server settings for the switch. DHCP uses UDP as its
transport protocol and supports a number of features that facilitate in administration address allocations.
ip dhcp pool
This command configures a DHCP address pool name on a DHCP server and enters DHCP pool configuration mode.
no ip dhcp pool
This command removes the DHCP address pool. The name should be previously configured pool name.
client-identifier
This command specifies the unique identifier for a DHCP client. Unique-identifier is a valid notation in hexadecimal format.
In some systems, such as Microsoft DHCP clients, the client identifier is required instead of hardware addresses. The
unique-identifier is a concatenation of the media type and the MAC address. For example, the Microsoft client identifier for
Ethernet address c819.2488.f177 is 01c8.1924.88f1.77 where 01 represents the Ethernet media type. For more information,
refer to the “Address Resolution Protocol Parameters” section of RFC 1700, Assigned Numbers for a list of media type
codes.
no client-identifier
This command deletes the client identifier.
client-name
This command specifies the name for a DHCP client. Name is a string consisting of standard ASCII characters.
Default none
Format
ip dhcp pool <name>
Mode Global Config
Format
no ip dhcp pool <name>
Mode Global Config
Default none
Format
client-identifier <uniqueidentifier>
Mode DHCP Pool Config
Format
no client-identifier
Mode DHCP Pool Config
Default none
Format
client-name <name>
Mode DHCP Pool Config