D-Link DWS-4000 Series, Cli Command Reference

Page: 356 / 566

D-Link Unified Switch CLI Command Reference
348
© 2009 D-Link Corporation. All Rights Reserved
no trapflags
This command disables all captive portal SNMP traps when no parameters are specified. The optional parameters specify
individual traps to disable.
authentication timeout
This command configures the authentication timeout. If the captive portal user does not enter valid credentials within this
time limit, the authentication page needs to be served again in order for the client to gain access to the network. The
<timeout>
variable is the authentication timeout and is a number in the range of 60-600 seconds.
no authentication timeout
This command sets the authentication timeout to the default value.
show captive-portal
This command reports status of the captive portal feature.
show captive-portal status
This command reports status of all captive portal instances in the system.
Format
no trapflags [{client-auth-failure | client-connect |
client-db-full | client-disconnect}]
Mode Captive Portal Config
Default 300
Format
authentication timeout <timeout>
Mode Captive Portal Config
Format
no authentication timeout
Mode Captive Portal Config
Format
show captive-portal
Mode Privileged EXEC
Field Description
Administrative
Mode Shows whether the CP is enabled.
Operational Status Indicates whether the CP operational status is enabled or disabled.
Disable Reason If CP is disabled, this field displays the reason, which can be None, Administratively Disabled, No IPv4
Address, or Routing Enabled, but no IPv4 routing interface.
Captive Portal IP
Address Shows the IP address that the captive portal feature uses.