D-Link DWS-4000 Series, Cli Command Reference

Page: 275 / 566

267
Access Point Profile RF Commands
If the user attempts to change the radio mode to one that is not applicable to that radio, then the following error displays:
(DWS-4026) (Config-ap-profile)#radio 1
(DWS-4026) (Config-ap-radio)#mode bg
Failed to set physical mode for radio interface.
no mode (AP Profile Radio Config Mode)
The
no
version of this command is used to return the configured radio mode to the default, which for radio 1 is an and for
radio 2 is bgn.
rf-scan other-channels
This command enables the radio to perform RF scanning on channels other than its operating channel. The optional interval
parameter indicates how often the radio leaves its operational channel.
no rf-scan other-channels
The
no
version of this command disables scanning on other channels; the radio will always scan on its operational channel.
rf-scan sentry
This command enables dedicated RF scanning and disables normal operation of the radio. The radio will not allow any client
associations when sentry mode is enabled.
bgn Indicates 802.11b/g/n as physical mode. Only applicable for radio 2.
n-only-a Indicates 802.11n in 5GHz band as physical mode. Only applicable for radio 1.
n-only-g Indicates 802.11n in 2.4GHz band as physical mode. Only applicable for radio 2.
Format
no mode
Mode AP Profile Radio Config
Default • Enabled
• interval, 60 seconds
Format
rf-scan other-channels [interval <30-120>]
Mode AP Profile Radio Config
Parameter Description
interval Interval at which the AP will move away from its operating channel.
30-120 Time interval in seconds.
Format
no rf-scan other-channels
Mode AP Profile Radio Config
Parameter Description