D-Link DWS-4000 Series, Cli Command Reference

Page: 269 / 566

261
Access Point Profile Commands
A
CCESS
P
OINT
P
ROFILE
C
OMMANDS
The commands in this section provide configuration of access point profiles. Access point profiles can be applied to multiple
physical APs.
ap profile
This command adds an AP profile (if not already present) and enters the AP profile configuration mode. In this mode, you
can modify the profile configuration parameters. You can modify an AP profile at any time. If the profile is associated with
one or more Managed APs, you must use the
wireless ap profile apply
command to send the changes to those
APs.
no ap profile
The
no
version of this command deletes a configured AP profile. If the profile is referenced by an entry in the valid AP
database, or is applied to one or more managed APs, it cannot be deleted. The default profile (1 – Default) can never be
deleted.
Example:
The following shows an example of the command.
DWS-4026 (Config-wireless)# ap profile 1
DWS-4026 (Config-ap-profile)#
If the profile is in use:
DWS-4026 (Config-wireless)# no ap profile 2
One or more managed APs are configured with this profile, it cannot be deleted.
name
This command allows you to configure a descriptive name for the AP Profile.
Default 1 - Default
Format
ap profile <1-16>
Mode Wireless Config
Parameter Description
1-16 Identifier for the AP Profile.
Format
no ap profile <1-16>
Mode Wireless Config
Default Default (AP profile 1)
Format
name <name>
Mode AP Profile Config