D-Link DWS-4000 Series, Cli Command Reference

Page: 245 / 566

237
Local Access Point Database Commands
L
OCAL
A
CCESS
P
OINT
D
ATABASE
C
OMMANDS
The commands in this section provide configuration of the local valid AP database. These configurations may also be
performed on an external RADIUS server.
ap database
This command adds an AP to the local valid AP database (if not already present) and enters the AP configuration mode
identified by the AP MAC address. In AP configuration mode, you can configure parameters for each individual valid AP.
Note that if a valid AP is already being managed by the switch, you need to reset the AP to pick up any configuration changes
in the valid AP database. The valid AP database parameters are read only when the AP is validated during discovery.
no ap database
The
no
version of this command deletes the AP entry for the specified MAC address from the local database or all the entries
present in the database.
mode (AP Config Mode)
This command configures the managed mode for an AP.
location
This command configures a descriptive string for the AP location.
Format
ap database <macaddr>
Mode Wireless Config
Parameter Description
macaddr MAC address of a physical AP.
Format
no ap database [<macaddr>]
Mode Wireless Config
Default ws-managed
Format
mode {ws-managed | standalone | rogue}
Mode AP Config
Parameter Description
ws-managed AP is managed by the Unified Switch upon discovery.
standalone AP is managed as a standalone AP and should not be reported as rogue by the Unified Switch.
rogue AP is identified as an administrator-configured rogue AP and will be reported as rogue upon discovery.