D-Link DWS-4000 Series, Cli Command Reference

Page: 201 / 566

193
Routing Information Protocol Commands
no distribute-list out
This command is used to specify the access list to filter routes received from the source protocol.
ip rip authentication
This command sets the RIP Version 2 Authentication Type and Key for the specified interface. The value of
< type >
is either
none
,
simple
, or
encrypt
. The value for authentication key [
key
] must be 16 bytes or less. The [
key
] is composed of
standard displayable, non-control keystrokes from a Standard 101/102-key keyboard. If the value of
< type >
is
encrypt
, a
keyid in the range of 0 and 255 must be specified. Unauthenticated interfaces do not need an authentication key or
authentication key ID.
no ip rip authentication
This command sets the default RIP Version 2 Authentication Type for an interface.
ip rip receive version
This command configures the interface to allow RIP control packets of the specified version(s) to be received.
The value for
< mode >
is one of:
rip1
to receive only RIP version 1 formatted packets,
rip2
for RIP version 2,
both
to
receive packets from either format, or
none
to not allow any RIP control packets to be received.
no ip rip receive version
This command configures the interface to allow RIP control packets of the default version(s) to be received.
ip rip send version
This command configures the interface to allow RIP control packets of the specified version to be sent. The value for
< mode >
is one of:
rip1
to broadcast RIP version 1 formatted packets,
rip1c
(RIP version 1 compatibility mode) which sends RIP
Format
no distribute-list <1-199> out {static | connected}
Mode Router RIP Config
Default none
Format
ip rip authentication {none | {simple <key>} | {encrypt <key> <keyid>}}
Mode Interface Config
Format
no ip rip authentication
Mode Interface Config
Default both
Format
ip rip receive version {rip1 | rip2 | both | none}
Mode Interface Config
Format
no ip rip receive version
Mode Interface Config